Load Item...


ModBUS Digital Anemometer

KET-WNM-100 is a digital anemometer, suitable to monitoring wind turbine and control of wind speed in ski lifts, motorways, Alpine hiking, etc.

Created to improve the reliability of measurements compared with analogic anemometers cups. The sensor is mechanically designed to provide also a mechanic plug&play.

The adoption of RS485 digital output follows the technological development already used in other fields, and allows a considerable simplification in wiring in the stations that require reading of more tools, allowing you to create a single chain (bus) where converge data from different sensors.

Provided with anti-icing System.

KET-WNM-100 comes with a 4-pin M8 connector, which enables faster installation and maintenance, but also the possibility of a multi plug&play probes for easier maintenance checks.

Compatible (on RS485 bus) with Bridge KET-RMB-211 and Gateways X-Monitor.

GENERAL SPECIFICATIONS
Protection Tropicalized electronic circuit
Protection Range IP65
Operative Temperature ± 3 °C (-30 ÷ +80 °C)
Dimensions 30h x 15 Ø cm
Mounting With 3 screws for direct mounting on poles up to Ø 35mm
Material Galvanized steel and aluminium
Cable Diameter L= 3 m with 4 conductors
Heater Options Thermoregulated anti icing
POWER SUPPLY
Supply Voltage 5 ÷ 24 VDC / 9 ÷ 28 VAC - Protected against polarity reversal and overvoltage
Consumption Consumption < 500 mW (excluding heater)
RS485 INTERFACE
Supported Protocols ModBUS RTU
Isolation Galvanically isolated from the power supply, protected against short circuit and overvoltage
WIND SPEED
Wind Speed 0 ÷ 50 m/s (0 ÷ 180 km/h)
Outputs Average and max: instantaneous 1 min - 2 min - 3 min
Accuracy ±5%
CERTIFICATIONS
Metrology IEC61400-12-1
© 2019 Kerberos. All Rights Reserved. | MaggiorDOMO is a registered trademark of Kerberos S.r.l. Unipersonale - VAT IT-03929170284 - R.E.A. 348334 - C.C.I.A.A. 03929170284 - Share Capital € 100.000,00 - Privacy Policy- Cookie Policy- Cookie Settings