ModBUS Power Meter with display for Continuous Current with Hall effect sensor included
The KET-MDC-410 allows the measurement of direct currents up to a maximum of -2500/+2500 A using a small Hall sensor connected with a convenient 2m long cable.
The display, which is equipped, allows the calibration of the sensor through the integrated menu and shows the reading in Ampere.
It is equipped with an RS485 interface with ModBUS RTU protocol compatible with KET-RMB-211 ModBUS bridge/Master and X-Monitor Gateways.
The KET-MDC-410 is powered by both low voltage and 230 VAC with integrated power supply and can be mounted on both DIN rail and wall.
GENERAL SPECIFICATIONS
| Protection Range | Front: IP40; Screw Terminals: IP20 |
| Operative Temperature | -20 ÷ +60 °C |
CASE
| Dimensions | 88 x 110 x 60 mm (W x H x D) |
| Mounting | Wall mounting or on DIN rail |
| Required DIN modules | 5 DIN modules |
| Electric Board Type | Industrial or switchboard |
| Material | Blend PC/ABS self extinguishing UL94-VO |
POWER SUPPLY
| Supply Voltage | 12 ÷ 48 VAC, 20 ÷ 60 VDC and 230 VAC with integrated power supply |
| Consumption | < 1.5 W @ 12 ÷ 48 VAC / < 1.5 W @ 20 ÷ 60 VDC / < 1.5 W @ 230 VAC |
| Connectors types | Screw terminal |
RS485 INTERFACE
| Supported Protocols | ModBUS RTU |
| Connectors types | Screw terminal |
CURRENT SENSOR
| Sensor Type | Hall effect probe |
| Current Range | -2500 ÷ +2500 A |
| Typical Sensitivity | 280 V/T |
| Linearity | ±0.2% |
| Linearity Range | -7.5 +7.5 mT |
| Nonlinearity | ±1% |
| Temperature Drift | < ±200 ppm/°C |
| Noise Spectral Density | <125 nT/sqrt(Hz) (f = 10 Hz ÷ 10 Hz) |
Accounting
© 2019 Kerberos. All Rights Reserved. | MaggiorDOMO is a registered trademark of Kerberos S.r.l. Unipersonale - VAT IT-03929170284 - R.E.A. 348334 - C.C.I.A.A. 03929170284 - Share Capital € 100.000,00 -
Privacy Policy-
Cookie Policy-
Cookie Settings